When I had Windows 8.1, there was a power option for "High Performance" which allowed higher performance at the cost of power supply.
Is there a way to set my power option to "High Performance" on Linux?
performancepower-management
When I had Windows 8.1, there was a power option for "High Performance" which allowed higher performance at the cost of power supply.
Is there a way to set my power option to "High Performance" on Linux?
Best Answer
To view available speed governors use this command:
If you do have more than one governor you can check what is currently in use with this command:
To change your processor to performance mode use:
You will then notice CPU% utilization drop by about 5% but also notice speed will increase from about 1000 MHz to 3000 MHz and temperatures will spike by ~10 degree, depending on your processor:
I have noticed that even when set to powersave mode (as I always use) when Ubuntu first boots it runs in performance mode for 90 seconds before it eventually kicks into powersave mode.
None-the-less after manually setting the governor to performance mode using the appropriate command above. It has stayed in performance mode for 10 minutes now as confirmed by using the appropriate command above and doubly confirmed by conky display above.
I left the governor set on
performance
for 30 minutes and it worked just fine. It might interest some readers what the conky display looks like when switching off of performance governor back to the default powersave governor:CPU% utilization has spiked by 5%, but CPU frequency has dropped by 1500 MHz and temperature has decreased by about 10 degrees. Overall I think powersave mode is the best for most configurations.
Conky Code
April 12, 2019 - Someone requested conky code so I'm including today's version. The refresh rate is set at 2.5 seconds today whereas in .gifs it's probably 1 second or .75 second. I've edited the code a bit here because mine is setup for three monitors and most people will have one monitor.
The storage section is a little tricky. You need to change the device names to your own and there are
if
tests if a partition isn't mounted shows system information like cache and buffers.Bottom half of conky screenshot
Just noticed the conky images above are top half only. The bottom half is included below so the code makes more sense. Also note the Intel iGPU appeared before because
prime-select intel
was used. Here the nVidia GPU appears becauseprime-select nvidia
was used: