I'm trying to diagnose an issue with a Mac Pro Early 2008. When I received it, it just doesn't boot: when I pushed the power button, it started for less than a second, and then it automatically shutted down. No chime, no gray screen, no apple logo.
I opened it, removed one of the memory risers, and kept pressed the diagnostic button when I started it. After doing it, the Mac booted properly. When I reinserted the memory raiser, it just won't boot, but the power led stays on anyway (not shutting down after 2 secs)
So, I returned the mac to the owner and it worked by one day. At the next day he had the same trouble. I instructed him to open the case, press the Diag button, and it just started again.
But, I have a few questions: is this related to the SMC? As i seen before, letting the computer unplugged for 15 seconds is "enough" to reset the SMC, and Mac Pro, from Early 2008 doesn't have a SMC_RST button. What I'm doing when I press the Diagnostic button then? Why it boots when I do that?
And, on the other hand, where can I find a place to interpret what diagnostic leds are telling me.
Thanks guys!
Best Answer
From what you've described/tried so far this sounds like it's a RAM related issue.
Keep track of which RAM is which (label each stick) and experiment with different configurations. The most important thing to try out would be swapping the RAM between the reisers and testing. This should help you ascertain if it's the particular reiser that's at fault or the RAM in that reiser.
Also, make sure that the RAM configuration is correct! Check that it is here
You may also want to consider the PSU, logic board or CPUs - really though only an Apple tech with access to known good spares can really confirm this.
Regarding the SMC; When you unplug the machine for more than 15 secs the SMC resets. This is the official way to reset the SMC, hence the lack of a reset button.
When you press the diag button you are doing nothing more than telling the system to light up some extra diag LEDs that are usually not lit during standard boot procedure.
See this table for a list of boot/diag LEDs
The system will boot when you press this button because the LEDs are used to check that the system is getting through the various POST (power on self tests) during boot. The LEDs can tell you where and why the boot is failing.