Instructions how to set-up samsung CLX-3185FW.
Source: baltas125@ubuntuforums. Originally taken from: bchemnet.
From the 1st link:
After executing instructions I have successfully installed CLX-3185FW over the network. It prints and scans over the network. I have made it on Ubuntu 11.10, 32bit.
Before installing you MUST REMOVE any other previously installed drivers for Samsung.
Step 1 (edit sources):
sudo gedit /etc/apt/sources.list
Add lines:
#samsung drivers
deb http://www.bchemnet.com/suldr/ debian extra
Step 2 (install authentication key) :
wget -O - http://www.bchemnet.com/suldr/suldr.gpg | sudo apt-key add -
Step 3 (update sources):
sudo apt-get update
Step 4 (install packages):
Open ubuntu software center and install one by one all packaged that start with samsungmfp-
, excepting:
- first install packages which do not have the word "legacy";
- do not install packages which offer you to remove any other packages;
- Do not install
samsungmfp-parallel
it should only be installed if your printer is actually connected via a parallel port;
Step 5a (check if you are in lp group). Run in Terminal:
cat /etc/group | grep lp
If your account name is next to lp, everything is ok, else add yourself to lp group, e.g. execute Step 5b.
Step 5b (add yourself into lp group if needed):
sudo usermod -a -G lp USERNAME
(more information about groups here)
That's it! Now you can search for your printer in network and add it as clx-3180 series and it will work.
P.S. Previously I have made some changes to some files. But I do not know if it has any impact. If you have executed the five step above and still no luck, try making those changes:
/etc/sane.d/xerox_mfp.conf
lines added
#Samsung CLX-3170fn & CLX-3175FW
usb 0x04e8 0x342a
In ...
/etc/sane.d/xerox_mfp.conf
lines added:
#Samsung CLX-3185FW
usb 0x04e8 0x343d
In ...
/lib/udev/rules.d/40-libsane.rules
lines added:
# Samsung CLX-3185FW
ATTRS{idVendor}=="04e8", ATTRS{idProduct}=="343d", ENV{libsane_matched}="yes"
Best Answer
This is a kind of an old question, but I had similar issues in Ubuntu 18.04.
The problem in my case was USB3. After putting the cable to an USB2 input, it worked all fine.
This has been discussed here (in french language): https://forum.ubuntu-fr.org/viewtopic.php?id=2023391