Windows – Slow network file access with VMWare Server and Windows 7

vmware-serverwindows 7

I have Windows 7 32-bit virtual machine running in a VMWare Server virtual machine. The host is Windows 7 64-bit.

When I copy files between them it is extremely slow – it will take several minutes to copy even a 1 MB file. I can upload the file to an website and then download it again almost instantaneously by comparison.

Browsing the network is quite zippy and has no problems. I have been unable to set up a HomeGroup between the computers though – the guest always times out without managing to get setup.

Any ideas on how I should go about tracking down where the problem is?

Best Answer

I've been searching for this myself on the forums. And I've eventually found the solution on VMWare's KB here

Basically it tells you to disable TCP Offloading which means your host/guest traffic is actually being sent to the NIC when all you need is for it to stay local.

My NIC driver under device manager also had additional Offload options such as checksum offloading.. I've disabled these too...

My file xfer speed between Host to Guest has now gone from 30kb/s to 50MB/s ... much better! :) Just posting it here for the benefit of future googlers...

p.s. in my case, the new settings took effect without a reboot... the NIC reset itself after changes to the driver, I've also done an ipconfig /renew on the guest.. neither host nor guest were down for this.

cheers

keywords: slow vmware server network traffic copy file guest host tcp ip LAN SMB UNC shared folders

Related Solutions

Windows – Connect to CentOS httpd server running on VMware Player

I ran into this recently, and it turned out to be a firewall issue. The default iptables blocked any incoming port (except ssh).

Here's an intro on iptables if you're not familiar with it: http://wiki.centos.org/HowTos/Network/IPTables

And you need to make sure to at least allow port 80 incoming.

Windows 7 kills VMWare performance by disk caching

See the last entry here http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1008885

I have seen huge improvements to VM performance after making this change. Just make sure you have enough memory on your host.

Edit the virtual machine settings to reduce I/O usage by using more host memory:

Adding these settings to a virtual machine can reduce the I/O load on the hard disk, however these adjustments require additional memory on the host. Only add these settings if there is sufficient free memory on the host to accommodate all the memory allocated to the virtual machine, otherwise you may cause a memory starvation condition that can reduce performance of all the running virtual machines or possibly affect the host operating system. Use these settings with caution.
Open the .vmx file for the affected virtual machine while it is powered off. Add the following lines to the file using a text editor. For more information, see Editing the .vmx file of a VMware Workstation and VMware Player virtual machine (2057902)

Note: If you are using VMware Server, you may need to restart the VMware Authorization Service (vmware-authd) for changes to take effect.
MemTrimRate = "0" 
mainMem.useNamedFile = "FALSE"
sched.mem.pshare.enable = "FALSE" 
prefvmx.useRecommendedLockedMemSize = "TRUE"
Note: If you are using a Linux host, use the following entry instead of mainMem.useNamedFile = "FALSE". The mainMem.useNamedFile entry only applies to Windows Hosts.
mainmem.backing = "swap"

Best Answer

Related Solutions

Windows – Connect to CentOS httpd server running on VMware Player

Windows 7 kills VMWare performance by disk caching

Related Question