How to configure new D-Link DSL-2320B modem replacing Motorola modem that needs two ice pack to operate. Wireless router is D-Link DIR-655. Am able to talk to the modem 192.168.1.1 and the router 192.168.0.1 via wireless. Account with att.com.
The existing ice-pack modem has:
- [PPP on the modem] Mode
- [0] VPI
- [35] VPI
- [Never] Timeoput
- [151.164.184.145] IP Gateway
Current attempt on the new modem:
ATM PVC Configuration.
- (-) DSL Auto-connect
- [0] VPI
- [35] VCI
- [X] PPP over Ethernet (PPPoE)
- [VCMUX|LLC/SNAP-BRIDGING] Encapsulation Mode
- [AUTOPAP|CHAP|MSCHAP] Authentication Method
- (?) Dial on demand (with idle timeout timer)
- [???] Inactivity Timeout (minutes)
- (?) PPP IP extension
- (?) Keep Alive
- (?) Use Static IP Address
- (?) Obtain default gateway automatically
- (?) Use the following default gateway:
- [???] Use IP Address
- [???] Use WAN Interface
When unplugging phone line from the existing modem then plugging phone line into the new modem and letting it "auto-connect" it says that 0/35 is busy and tries a bunch of other values.
Powering down the existing modem overnight did not change the result.
Telling the existing modem to "disconnect" did not change the result.
Best Answer
Take the D-Link modem, receipt and a twenty dollar bill to the retailer, come home with a Motorola 2210-02, plug in cables, enter username/password and resume surfing (keep ice packs ready for next spring). This is the fourth modem with the Motorola logo.