I have a set of Logitech 5.1 speakers where each speaker and the source plug into the subwoofer. I'm using a Griffin Firewave with output from my MacBook Pro, and output from my custom-built desktop with a switch in the middle (built it myself out of an old Belkin A/B parallel switch)).
Recently, I've noticed that I can hear a local Punjabi radio station being picked up by my speakers, and the volume of this interference increases as I increase the volume of the speakers. I'm fairly sure that this radio station is at the low-end of the FM spectrum, below 90MHz (or it may be at the high end, above 105MHz, my memory isn't infallible). It gets quite annoying as I can't put my audio very loud without the interference.
I've tried to put a ferrite core on the input cable just before the 3.5mm jacks plug into the subwoofer. I don't know if putting the same core around all three of the cables (green, black, orange) would negate the effects, but I'm assuming not. There has been no change.
Is there any reason why this would be happening? I'm assuming the interference is coming somewhere between the FireWave and the subwoofer, because the noise gets amplified with volume increases. If anybody has any suggestions, I'd be grateful!
Best Answer
It's probably your cables picking up the signal from a transmitter that is close to your home. Usually this is caused by folded cables (Like when you neatly tie them together). If you have folded cables or lots of cables tied together, try if unfolding them or seperating the speaker cable from the rest helps.