Mongodb – 502 error after restarting mongo db in remote server using fork command

It is possible that mongodb.conf is not getting loaded because of wrong location (typically this is /etc/mongodb.conf) or a typo when you launch through service start

Try launching manually

mongod --config /etc/mongodb.conf

to rule out any issues with the conf file.

The solution to this issue was as follows: Starting with the secondary:

Inside of Mongo I ran the following:

db.shutdownServer()
exit

On the command line:

rm -rf /var/lib/mongodb/*
sudo service mongodb start

It then takes a couple of hours to resync. Once resynced I did the following on the primary:

rs.status() //To make sure that the everything was synced
rs.stepDown(9200)
db.shutdownServer()
exit

On the command line I ran:

rm -rf /var/lib/mongodb/*
sudo service mongodb start

Then in Mongo I ran:

rs.status() //To make sure that everything was synced
rs.freeze(0) //To remove the re.stepDown(9200) lock

On the secondary I ran:

rs.stepDown()

Note: If possible, back up all of your data first.