Since I updated my MBP, it doesn’t work anymore. Had trouble installing, then it was slow, and now I can’t do anything anymore other then going into Recovery mode. When running Disk Ultility, it always tell me while running First Aid, that there is an error: cib: o_oid(0x0)
File system check exit code is 0.
I don’t know what to do anymore.
MacOS – Can’t get the MBP running since macOS Mojave
macosmojave
Related Question
- MacOS – Macbook Pro stuck booting after Sierra 10.12.1 update
- MacOS – How to fix Mac “file system or verified failed”
- Upgrade from High Sierra to Mojave corrupted the partition table, unusable MBP
- MacBook – How to update the EFI firmware of a replacement logic board of a MBP mid-2015 to make it compatible with Mojave
- MacOS – Can’t backup OSX Mojave because it thinks FileVault is running
Best Answer
Lets try to repair your disk in Single User mode.
Hold Shift key during start up.
Let it finish ..
then enter
When it’s done, you’ll see a message saying “** The volume [name] appears to be OK” if everything is fine.
If it found problems, you’ll see a “***** FILE SYSTEM WAS MODIFIED *****” message. This indicates the fsck command found and fixed problems. The fsck command may find additional errors after repairing the first batch of errors, so Apple recommends you run the fsck command again if it found and fixed problems. Run the above fsck command over and over until you see a “** The volume [name] appears to be OK” message.
When the fsck command says your disk is okay, type the following command at the terminal and press Enter: